2003 Nissan Frontier Recalls

The riskThe shaft may break which could result in loss of steering control during these low speed maneuvers increasing the risk of a crash.

The fix — freeThe steering column shaft and joint will be replaced with a shaft of a different design. This service will be performed free of charge. The recall began on december 13, 2010. Owners may contact nissan at 1-800-647-7261.

What was foundNissan is recalling certain model year 2002-2004 frontier vehicles manufactured from july 9, 2001 through october 20, 2004, and model year 2002-2004, xterra vehicles manufactured from july 9, 2001, through january 6, 2005. Over time corrosion may form in the lower steering column joint and limit movement of the joint. The limited movement of this joint may create excessive load on the lower steering column shaft. If the vehicle continues to be driven in this condition, it may lead to cracking of the shaft during low speed maneuvers that require large steering inputs.

The riskDecreased lighting visibility may result in a vehicle crash.

The fix — freeSabersport will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on may 11, 2009. Owners may contact sabersport at 1-909-598-7589.

What was foundSabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment." These lamps do not contain the required amber side reflectors.

The riskLack of amber side reflectors in the lamps will decrease lighting visibility to other drivers and may possibly result in a vehicle crash.

The fix — freeTradesonic will notify owners and replace the lamps free of charge. The recall is expected to begin during july 2006. Owners may contact tradesonic at 626-934-8884.

What was foundCertain tradesonic combination lamps sold as replacement lamps for use on the above listed passenger vehicles. Combination lamps not equipped with amber side reflectors fail to conform with the requirements of federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

The riskWithout the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash.

The fix — freeAnzo will notify owners and replace the headlamps free of charge. The recall began may 9, 2006. Owners may contact anzo usa at 909-468-3688.

What was foundCertain anzo combination headlamp assemblies sold as replacement lamps for use on certain passenger vehicles. Some combination lamps are not equipped with amber side reflectors which fail to conform to federal motor vehicle safety standard no. 108, "lamps, reflective devices, and associated equipment."

The riskIf corrosion occurs, the terminal strip could eventually break causing the fuel pump to stop operation. This will result in not being able to start the engine or cause the engine to stop running without warning, which can result in a crash.

The fix — freeIn the following states, dealers will replace the fuel-sending unit. These states are connecticut, delaware, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, tennessee, vermont, virginia, west virginia, wisconsin, and the district of columbia. In the other states, the dealer will inspect the fuel pump terminal on the sending unit for corrosion. If corrosion is present, the dealer will replace the unit. If there is not corrosion, the dealer will apply sealant to the terminal housing to help prevent corrosion in the future. Owner notification began on june 28, 2004. Owners should contact nissan at 1-800-647-7261.

What was foundOn certain pickup trucks equipped with six cylinder engines and sport utility vehicles equipped with four or six cylinder engines, the fuel pump terminal on the fuel-sending unit can develop a crack in the plastic molding. This can cause the terminal strip to corrode under some environmental conditions.

The riskWhen installed on the front of the vehicle, the wheel rim will contact the brake caliper causing a loud rubbing noise and could result in wear on the caliper and/or wheel rim if driving continues. Continued usage of the spare tire wheel at the front location can also result in loosening of the lug nuts and deterioration in braking performance. This could eventually cause the wheel assembly to separate form the vehicle and result in loss of control and a crash.

The fix — freeDealers will replace the spare tire wheel rim with a new one, and remount the spare tire on it. Owner notification began january 13, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact nissan at 1-800-647-7261.

What was foundOn certain sport utility vehicles equipped with a V6 engine, an incorrect size wheel rim for the spare tire was provided in these vehicles. The wheel rim does not fit properly as a replacement for a front wheel.

The riskThis can result in corrosion and eventual failure of the wheel bearing. If this occurs, the wheel assembly could separate from the vehicle increasing the risk of a crash.

The fix — freeDealers will inspect the rear axle for water intrusion and any affected components will be replaced. The abs sensor will be resealed to prevent water intrusion. Owner notification began december 10, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact nissan at 1-800-647-7261.

What was foundOn certain pickup trucks and sport utility vehicles, water may enter the rear axle housing due to inadequate sealing of the anti-lock braking system (abs) sensor.