2003 Chevrolet Suburban Recalls

The riskThis condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. In the presence of an ignition source, a fire could occur.

The fix — freeHoneywell will notify owners and replace the fuel filters free of charge. The recall began on october 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).

What was foundCertain replacement fuel filters, fram brand name p/n G3727, with date codes X52911 through X60801 sequentially or X600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.

The riskWithout the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.

The fix — freePro-a motors will notify owners and offer to repurchase the lamps. The recall began on april 3, 2006. Owners may contact pro-a motors at 323-838-2988.

What was foundCertain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.

The riskA lap portion of the seat belt routing that is not low and snug on the hips can allow the lap belt to ride up on an occupant's abdomen instead of fitting low around their hipbones, and therefore, can expose them to more risk of abdominal and internal organ injury.

The fix — freeDealers will cut open the guide loop, remove a portion of the loop, and then the remaining two sides should be folded over and secured with a retainer free of charge. The recall began on july 21, 2005. Owners may contact cadillac at 1-866-982-2339, chevrolet at 1-800-630-2438, gmc at 1-866-996-9463, or hummer at 1-800-732-5493.

What was foundOn certain crew cab pickup trucks and sport utility vehicles, the 2ND row center occupant seat belt routing may make it difficult to position the lap portion of the safety belt low around the hips of occupants, especially smaller occupants, seated in this position. Appropriate use of a child seat or booster seat, as recommended for small children, does improve the fit condition for this user group. In addition to instructions on proper infant and young child restraint (with child seats or boosters), special verbiage for restraining older child is included in the owner's manual. Also, the suggested seat belt fit/routing for adults, irrespective of seating position, is described in the owner's manual text.

The riskConsequently, the valve o-ring seal may fracture. Steering efforts may be slightly increased while braking or parking. Under certain driving conditions, a fractured seal may require a slight increase in the applied brake pedal effort to achieve the same vehicle deceleration rate as prior to the seat fracture.

The fix — freeDealers are to replace the hydro-boost relief valve. The recall began on june 18, 2004. Owners should contact cadillac at 1-866-982-2339; chevrolet at 1-800-630-2438; gmc at 1-866-996-9463; or hummer at 1-866-486-6376.

What was foundCertain sport utility vehicles, pickup trucks, and passenger vans fail to comply with the requirements of federal motor vehicle safety standard no. 135, ?passenger car brake systems.? Some of these vehicles were produced with an out-of-specification brake hydro-boost housing relief valve bore.

The riskThis overheating condition can cause the running board to melt or cause a fire.

The fix — freeDealers will replace the wiring harness on these running boards. Owner notification began march 7, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact southern comfort at 1-800-745-6096.

What was foundCertain pickup truck, van, and mini van conversions equipped with southern comfort built running boards that contain certain courtesy lights manufactured by american technology components, inc. These units contain a courtesy light or lights that might overheat when the wire harness is exposed to excessive moisture and road salt.

The riskAs a result, the door strength may be degraded during a side impact vehicle crash.

The fix — freeDealers will inspect the welds on the left rear door upper hinge. If a weld is found out-of-specification, a bolt will be installed to secure the hinge. Owner notification began february 17, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact cadillac at 1-800-458-8006, chevrolet at 1-800-222-1020, or gmc at 1-800-462-8782.

What was foundCertain sport utility vehicles fail to comply with requirements of federal motor vehicle safety standard no. 214, "side impact protection." These vehicles are built with four welds on the rear door upper hinge. On some of these vehicles, one or two of the welds may not be to specification.

The riskFuel leakage, in the presence of an ignition source, could result in a fire.

The fix — freeDealers will install a fuel tank shield. Owner notification began february 20, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020 or gmc at 1-800-462-8782.

What was foundOn certain pickup trucks and sport utility vehicles, vehicles, during a 30 degree left angle frontal impact of sufficient severity, a tear could develop in the mid-frame cross member at its attachment to the left frame rail. If the mid-frame cross member tears during frontal impact and produces a sharp edge, contact of the sharp edge with the fuel tank could result in a puncture of the fuel tank and possible fuel leakage.