2008 Toyota Highlander Recalls

The riskIf damaged, the copper strand heating element may short circuit, increasing the risk of a fire.

The fix — freeSET will notify owners, and dealers will disconnect the seat heaters, free of charge, and refund the purchase price of the seat heater accessory. The recall began on July 14, 2016. Owners may contact SET customer service at 1-866-405-4226. SET number for this recall is SET16B.

What was foundSoutheast Toyota Distributors, LLC (SET) is recalling certain 2005-2011 4Runner, Highlander, Sequoia, and Sienna, 2005-2010 Avalon and Tundra, 2006-2008 Camry Solara, 2006-2010 Highlander hybrid, 2006-2011 Rav4 and Tacoma, 2007-2010 FJ Cruiser, 2007-2011 Camry hybrid, 2009-2010 Venza, 2010-2012 Prius, 1988-1990 and 2005-2010 Camry, and 1989 and 2009-2010 Corolla vehicles equipped with aftermarket accessory seat heaters with a copper strand heating element. The electrical wiring in the seat heaters may be damaged when the seat cushion is compressed.

The riskIf the sliding electrical contacts are not protected by lubricant, debris and moisture that get into the switch may cause a short circuit and the switch assembly may overheat and melt, increasing the risk of a fire.

The fix — freeToyota will notify owners, and dealers will inspect the switch, applying a lubricant if no abnormality is found. If abnormality is found, the PWMS circuit board will be replaced, free of charge. The recall is expected to begin December 20, 2015. Owners may contact Toyota customer service at 1-800-331-4331. Toyota's number for this recall is C0M.

What was foundToyota Motor Company (Toyota) is recalling certain model year 2009-2011 Tundra, Sequoia, Corolla, Corolla Matrix and Scion xB, 2008-2011 Highlander and Highlander Hybrid, 2007 Camry and Camry Hybrid, 2009 Camry and Camry Hybrid, 2006-2011 RAV4, 2006-2010 Yaris, and 2009-2010 Scion xD and Pontiac Vibe vehicles. During the manufacturing of the Power Window Master Switch (PWMS), grease lubricant may have been inconsistently applied to the sliding electrical contacts.

The riskDamage to the seat heater wiring could cause the wires to short, increasing the risk of the seat burning and causing personal injury to the occupant.

The fix — freeSET will notify owners, and dealers will disconnect the heaters with copper strand heating elements and refund the purchase price of the seat heater accessory, free of charge. The recall is expected to began in January 2015. Owners may contact SET customer service at 1-866-405-4226.

What was foundSoutheast Toyota Distributors, LLC (SET) is recalling certain model year 2010-2011 Prius and Corolla, 2009-2011 Venza, 2006-2010 Avalon, 2007-2010 FJ Cruiser, 2005-2011 Sienna and Sequoia, 2006-2011 Tacoma 4x2 and 4x4, Camry, Highlander, Tundra 4x2 and 4x4, and 2007-2011 Rav4 and 4Runner. The affected vehicles may experience compression of the seat cushion which may damage the seat heater wiring.

The riskIf the FFC is damaged, connectivity to the driver's air bag module could be lost and the air bag deactivated. The failure of the driver's air bag to deploy in the event of a crash that typically necessitates deployment increases the risk of injury to the driver.

The fix — freeToyota will notify the Toyota vehicle owners, and General Motors will notify the Pontiac Vibe owners. Toyota sent owners an interim notification letter in May 2014 to advise owners of the recall. Toyota will mail owners a second letter when remedy parts are available. General Motors sent Pontiac Vibe owners an Interim letter on June 20, 2014 notifying them that parts are currently unavailable. General Motors sent notices to the Pontiac Vibe owners on September 15, 2014, that a remedy is available. The recall began on October 27, 2014. Owners may contact Toyota at 1-800-331-4331. Owners may contact General Motors at 1-800-762-2737.

What was foundToyota is recalling certain model year 2006-2008 RAV4, 2006-2010 Yaris, 2008-2010 Highlander, and 2009-2010 Tacoma, Corolla, Corolla Matrix and General Motors Pontiac Vibe vehicles. In the affected vehicles, the steering column assembly contains electrical connections to the driver's airbag module housed in a spiral cable assembly, which includes a Flexible Flat Cable (FFC). Due to the shape and location of the FFC's retainer, the FFC could become damaged when the steering wheel is turned.

The riskIf the switch overheats, it may melt, possibly resulting in a fire.

The fix — freeToyota will notify its owners, and dealers will inspect the switch and apply a special grease that inhibits heat build up or replace any switch damaged by the defect, free of charge. Toyota owners that experience a problem with a switch should not attempt to make repairs, but should contact their Toyota dealer or the Toyota Customer Experience Center at 1-800-331-4331. General Motors will contact the Pontiac Vibe owners affected by this recall and GM dealers will inspect and repair switches as necessary. Those owners may contact Pontiac Customer Care at 1-800-762-2737.

What was foundToyota is recalling certain model year 2007-2009 Camry, Camry Hybrid, RAV4, Corolla, Corolla Matrix, Tundra, Sequoia, Highlander, Highlander Hybrid, Yaris, Scion xB, Scion xD and Pontiac Vibe vehicles. The power window master switch assemblies in some of these vehicles were built using a less precise process for lubricating the internal components of the switch assemblies. Irregularities in this lubrication process may cause the power window master switch assemblies to malfunction and overheat.

The riskInadvertent activation of the csa and/or the seat belt pretensioner can cause injury to a vehicle occupant.

The fix — freeToyota will replace the airbag sensor assembly with a new one containing improved roll rate sensors, free of charge. Toyota intends to send an interim owner notification to owners early to mid-may, 2011 when sufficient parts and remedy becomes available. Owners may contact toyota at 1-800-331-4331.

What was foundToyota is recalling certain model year 2008 highlander, highlander hybrid, and model year 2007-2008 RAV4 vehicles. In the curtain shield airbag (csa) system, there are two sensors in the airbag sensor assembly which are designed to detect vehicle roll angle. If one of these sensors malfunctions, the airbag warning light (malfunction indicator light: mil) will illuminate and the roll detection system will be suspended; however, the airbag csa remains available in the event of a side crash. If both sensors fail nearly simultaneously after initial airbag system check, the csa and the seat belt pretensioner could be inadvertently activated.

The riskThis does not meet the standard requirements.

The fix — freeDealers will mail to consumers the corrected label or the customer will have the option for dealers to install the label free of charge. Dealers will also correct the owner's manual. The safety recall began on may 27, 2010. Owners may contact gulf states toyota at 713-580-3300.

What was foundGulf states toyota is recalling certain model year 2005-2010 vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 110, "tire selection and rims." These vehicles were sold between september 1, 2005 and june 2, 2008 without the requisite load carrying capacity modification labels.

The riskA driver may overload a vehicle which may increase the risk of a crash.

The fix — freeDealers will mail to consumers the corrected label or the customer will have the option for dealers to install the label free of charge. The safety recall began on may 27, 2010. Owners may contact southeast toyota at 1-800-301-6859.

What was foundSoutheast toyota is recalling certain model year 2005-2011 passenger vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 110, "tire selection and rims." These vehicles were sold without the requisite load carrying capacity modification labels.

The riskA stuck open accelerator pedal may result in very high vehicle speeds and make it difficult to stop the vehicle, which could cause a crash, serious injury or death.

The fix — freeToyota will modify or replace the accelerator pedals on the subject vehicles. Floor surface modifications are also being considered and will be included for any model for which it is deemed appropriate. Initially, dealers will be instructed on how to reshape the accelerator pedal for the repair. As replacement parts with the same shape as the modified pedal become available, they will be made available to the dealers for the repair. Customers who have had the pedal reshape remedy completed will have the opportunity to receive a new pedal if they desire, after replacement pedals become available. In addition, toyota will replace any toyota all-weather floor mat in a subject vehicle with a newly designed mat, free of charge. For those customers who have the previous design all-weather floor mat but do not need or want the newly designed all-weather floor mat, toyota will recover the previous design all-weather floor mat and reimburse its price. The safety recall began march 30, 2010. Owners may contact toyota at 1-800-331-4331.

What was foundToyota is recalling certain model year 2008-2010 highlander, model year 2009-2010 corolla, venza and matrix passenger vehicles. The accelerator pedal can get stuck in the wide open position due to its being trapped by an unsecured or incompatible driver's floor mat. This recall is an expansion of a campaign of 3.8 million other toyota vehicles announced in 2009 for the same issue (see 09V-388).

The riskIncorrect load carrying capacity modification labels could result in the vehicle being overloaded, increasing the risk of a crash.

The fix — freeToyota will notify owners and provide them with a new, accurate label to be installed over the inaccurate label free of charge. The safety recall began on august 18, 2009. Owners may contact toyota at 1-888-270-9371.

What was foundToyota is recalling 27,080 model year 2005 through 2010 passenger cars built from september 1, 2005 to may 4, 2009. These vehicles were not equipped with load carrying capacity modification labels which fails to conform with the requirements of federal motor vehicle safety standard no. 110, "tire selection and rims."

The riskThe original clamp and the toyota stainless steel exhaust tip may fall off the vehicle's exhaust pipe and become a road hazard which would increase the risk of a vehicle crash.

The fix — freeSoutheast toyota will notify owners and replace the clamp free of charge. The safety recall is expected to begin during may/june 2009. Owners may contact southeast toyota customer loyalty department at 1-800-301-6859.

What was foundSoutheast toyota is recalling 3,499 stainless steel exhaust tips sold by southeast toyota as an optional accessory for use on my 2008 highlander and highlander hybird vehicles. Due to improper heat treatment during the manufacturing process, the original clamp used to secure the stainless steel exhaust tip to the exhaust pipe may develop microscopic cracks. Eventually the crack may expand causing the clamp to break.

The riskThe original clamp and the toyota stainless steel exhaust tip may fall off the vehicle's exhaust pipe and become a road hazard which would increase the risk of a vehicle crash.

The fix — freeToyota will notify owners and replace the clamp free of charge. The safety recall began on may 4, 2009. Owners may contact toyota customer experience center at 1 888-270-9371 monday through friday, 5:00 am to 6:00 pm, saturday 7:00 am through 4:00 pm pacific time.

What was foundToyota is recalling 39,100 stainless steel exhaust tips sold by toyota as an optional accessory for use on my 2008 highlander and highlander hybrid vehicles. Due to improper heat treatment during the manufacturing process, the original clamp used to secure the toyota stainless steel exhaust tip to the exhaust pipe may develop microscopic cracks. Eventually the crack may expand causing the clamp to break.

The riskHowever, for the two third row dsp's on these vehicles, the alr mode deactivates before the webbing is fully retracted, so that it will not lock when certain rear-facing crs's that have a short seat belt routing path are installed in the vehicle. This can allow the seat belt webbing to spool out during normal driving maneuvers, which could affect the stability of a child restraint installed at those seating positions. As such, this could discourage the use of a child restraint and in the event of a crash, the child may not be adequately protected possibly resulting in injury.

The fix — freeDealers will install a newly designed seat belt component free of charge. The recall is expected to begin on or about december 18, 2008. Owners may contact toyota at 1-800-331-4331.

What was foundToyota is recalling 90,189 my 2008 highlander and highlander hybrid passenger vehicles equipped with a third row seat. These vehicles fail to conform to the requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." The non-driver designated seating positions (dsp) on these vehicles is equipped with seat belt assemblies that have a feature that converts the retractor from an emergency locking retractor (elr) to an automatic locking retractor (alr). The belts convert to the alr mode after the webbing has been fully withdrawn from the retractor. The system is designed so that as the belt is released into the retractor, the system remains in the alr mode so that a child restraint system (crs) can be tightly secured.