2005 Toyota Camry Recalls

The riskIf damaged, the copper strand heating element may short circuit, increasing the risk of a fire.

The fix — freeSET will notify owners, and dealers will disconnect the seat heaters, free of charge, and refund the purchase price of the seat heater accessory. The recall began on July 14, 2016. Owners may contact SET customer service at 1-866-405-4226. SET number for this recall is SET16B.

What was foundSoutheast Toyota Distributors, LLC (SET) is recalling certain 2005-2011 4Runner, Highlander, Sequoia, and Sienna, 2005-2010 Avalon and Tundra, 2006-2008 Camry Solara, 2006-2010 Highlander hybrid, 2006-2011 Rav4 and Tacoma, 2007-2010 FJ Cruiser, 2007-2011 Camry hybrid, 2009-2010 Venza, 2010-2012 Prius, 1988-1990 and 2005-2010 Camry, and 1989 and 2009-2010 Corolla vehicles equipped with aftermarket accessory seat heaters with a copper strand heating element. The electrical wiring in the seat heaters may be damaged when the seat cushion is compressed.

The riskIn some cases, the belt for the power steering pump may become detached from the pulley which could result in a loss of power steering and a sudden increase in steering effort, increasing the risk of a crash.

The fix — freeToyota will notify owners, and dealers will check the crankshaft pulley to identify whether it was produced by the u.s. Supplier. If so, the dealer will replace the pulley with a new one at no charge. The safety recall is expected to begin during early january 2012. Owners may contact toyota at 1-800-331-4331.

What was foundToyota is recalling certain model year 2004 avalon vehicles; 2004 and 2005 camry, camry solara, highlander, and sienna vehicles, 2006 highlander hybrid; 2004 and 2005 lexus ES330 and RX330; and 2006 lexus RX400H vehicles manufactured from june 1, 2004 through march 31, 2005, equipped with the 1MZ-FE or 3MZ-FE engine. The amount of adhesive agent applied between the outer ring and the torsional rubber damper (inner ring) in the crankshaft pulley may be inadequate. If the adhesive is insufficient, there is a possibility that the outer ring may become misaligned and it may not properly rotate with the inner ring, causing noise and/or illumination of the battery discharge indicator light.

The riskThis does not meet the standard requirements.

The fix — freeDealers will mail to consumers the corrected label or the customer will have the option for dealers to install the label free of charge. Dealers will also correct the owner's manual. The safety recall began on may 27, 2010. Owners may contact gulf states toyota at 713-580-3300.

What was foundGulf states toyota is recalling certain model year 2005-2010 vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 110, "tire selection and rims." These vehicles were sold between september 1, 2005 and june 2, 2008 without the requisite load carrying capacity modification labels.

The riskA driver may overload a vehicle which may increase the risk of a crash.

The fix — freeDealers will mail to consumers the corrected label or the customer will have the option for dealers to install the label free of charge. The safety recall began on may 27, 2010. Owners may contact southeast toyota at 1-800-301-6859.

What was foundSoutheast toyota is recalling certain model year 2005-2011 passenger vehicles for failing to comply with the requirements of federal motor vehicle safety standard no. 110, "tire selection and rims." These vehicles were sold without the requisite load carrying capacity modification labels.

The riskIf the switch becomes unseated, the front passenger occupant classification system may mistake the rear-facing child restraint for an unbelted adult occupant, and may not suppress the deployment of the front passenger airbag.

The fix — freeDealers will replace the front passenger seatbelt buckle status switch. This safety improvement campaign (ssc 40M) began on december 20, 2004. Owners should contact toyota at 1-800-331-4331 or lexus at 1-800-255-3987..

What was foundOn certain passenger vehicles equipped with a front passenger power seat, when installing certain rear-facing infant child seat bases onto the seat with an excessively high seatbelt tension, it may be possible to unseat a component called the buckle status switch from the seat belt buckle.